Just for clarification
The switch in the mirror turns on / off the Interior Mirror Auto Dim facility not the Auto Lights facility, that is controlled by the Master Light Switch.
Hi Damian_25
Not sure if this is any help. The screen should be a Green / Grey type and is available from National Windscreens 0800 616 122 Part No 8572LF0B.
The sensor fitted to the screen is only for the auto wiper system.
The Auto Lights On sensor is in the interior mirror. As you...
Split Fold rear seats were not standard on the A4 Tfsi Special Edition (220). I had to order mine in 2007 with split fold rears.
Just checked the old A4 spec sheet. No split fold rears for the 170 D either.
The 57.1mm is the diameter of the hole in the centre of the wheel. This has to match the hub assembly outside diameter. If the wheel has a bore diameter larger than 57.1mm then a spigot ring will be required to locate the wheel correctly.
I have moved from the Conti's to Toyo Proxes T1-R 235/40ZR18, you should be able to pick them up for around £120 fitted. I have only covered 5k on them but would rate them better that the Conti's for all round grip but road noise on some surfaces is a little higher. These are fitted on Genesis...
I purchased one from http://www.leisureshack.co.uk/ in Leicester and have had in the A4 for over a year.It has had all sorts of stuff thrown on it and has stood up well, just take it out and give it a wash - good as new. Can be collected if you are near Leicester.
Trex,
Not a good idea as it will cause issues with the intake gas temperature and emissions.
The following link will give you a short overview:
http://www.delphi.com/pdf/commercial/ElecDieselExhaust.pdf
Steve,
What I belive you are seeing is the difference in the cut out in the wheel house liner around the damper mounting. If you look at your photographs you will see the rim of the damper mounting cup, where the yellow damper bush is, in both pictures are in line with the damper mount...
Yes it is adjustable so that the sterring effort can be higher or lower at all speeds. I have driven a vehicle with full assist and it is very sensitive to driver input.
A3dude
Yes I have a 3.2 Sport DSG registered 1st September 04.
The part number for the 'correct' shocks is IKO 513029 HE as advised by Audi GmbH Engineering. They were fitted by Ipswich Audi.
The dealers as I understand it DO know about this but it looks as though they are fitting the 'new'...
Mike
I had this rear suspension noise from day one (1st September), reasonably quiet to start with but as the miles went on the noise got louder, after getting no where with the dealer I used a backdoor route into Audi GmbH Engineering. They advised that the problem was a quality issue with the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.