Search results for query: *

No ive not done that as i dont know how to do it. I put the reverse wire to the C2 pin and still nothing. im really confused has to why it wont work with the engine running

Make sure your wires are connected in the cambus properly and you have positive and negative connected or the tv wont work Ive sorted mine out today. it comes on when put into reverse and the TV mode has to be on. The grey wire on the multimedia ive left blank and the purple wire is the live...

still not sorted it out yet, im still waiting on the reverse camera from good old hong kong.

Hi guys, Any one help on this Im trying to install a reverse camera, I have a RNSE with a T-era multimedia adapter. On the yellow wire which I believe is the reverse cam wire there is a Purple and grey wire. Dose any one know where these need to be wired too. I have looked on the net and...

Ive just replaced my Balance shaft, Key and tension kit . Also while its a fairly big job I replaced the cambelt, water pump and put a new clutch in. The shaft key was totally rounded off and the shaft was pretty warn, So got onto ordering a recon shaft and key from...

Ive book my A4 in for this sat. Stage 1 so all been well it will go like st off a shovel ECU Remapping Audi VW BMW Seat Skoda Remap Chip Tuning

am starting to think the same

it drives fine although tick over seems a bit lumpy with the light on, its never gone into limp mode and seems no loss of power

yeah i got a new filter, checked the wiring but cant see any thing wrong. I cant figure out why the car drives fine but the fault keeps popping up

ya prob right.. i didnt i used the local motor parts shop for the air mass meter, surly both wouldnt make the fault show up?

hi guys I have a problem with the car A4 2L tdi 2006, I had the engine management light come on about 2 months ago so had the fault code show has P0101 (air mass meter) so got another air mass meter brand new. All ok for about a week then same thing happened light came back on and same fault...