Search results for query: *

Yes should be.

My car is lowered 20mm from factory, Fitted Bilstein eibach, Supposed to lower 30mm but took it down 10mm. I have pics of it on 8x18 et 43 with 235/40 tyres but cant see how to upload them the the page! Maybe you can help as I am new to the site, Or give me your email address so I can send them...

Gents, you need to remove your sump and rocker covers and clean them properly, im lucky my wife lets me put car parts in the dishwasher, My flush just losened off some deposits and cloged my pickup in the sump, i even had to manualy clean the inside of my block! This was on a car with 86k and...

Good luck getting diesel in a petrol car, The pump nozzle is too big to fit in most cars! if you suspect the MAF, Disconnect it and try to start the car, the ECU will revert to a predetermined value and let you condem it or rule it out! Failing that you are back to basic checks, compression...

Check the 12vdc and earth at the module itself, Then check the wire form the plug at the module and your 16pin dlc, I think it is purple but not sure! if they are all good, you have bought a u/s module. If the part number is the same it should not need recoded! good luck!

I did the full 8D S4 face lift brake upgarde on my sport quattro, and even my wife loves it, you will need, S4 wheel bearing housing's, (uprights) and depending what size your outer C/V joints are you may need to replace them too as the S4 uses an 82mm wheel bearing. My car is a 2000 model 1.8t...

Hi, new to the forum, I know this has been talked about before but without a conclusion as far as I can see. Thinking about doing a DBW conversion on my AJL for map availabilty reasons. I have a A4 AWT that let go of it's timing belt, So i have all the parts. Just wondering if anyone dealt with...