Audi A4 Atlas grey Sport with factory GMBH body kit.
6 speed manual, 130 1.9PD AVF with sensible re-map.
Does 48 measured MPG with my commute, with 52 indicated.
well maintained with correct PD spec oil. 221000 motorway miles.
I've owned it for over 5 years. Swan neck towbar - used once.
Cruise...
Are they intended for road use?
Be careful about going to 'racy', there's always a compromise with brake pad friction material,
There is no perfect friction material (no matter what the marketing BS tells you) which performs well cold/hot with no noise, low wear/dust etc.
I normally find OE...
If you are changing your whole clutch assembly/DMF then as long as the kit is the correct one for your car then it shouldn't matter either LUK or Sachs.
Tom.
I was woken one night a couple of weeks ago three time through the night by my alarm going off, (didn't go down too well with our new born!)
Next day I pulled a fault code 01368 - alarm from luggage compartment. I also noticed my boot light wasn't always going off when I closed the boot...
My diagnostics said 'blocked or no voltage' so I was presuming that it was electrical as they are generally set to on one temp and not adjusted, but thinking about it the flap will still have to move on cold start/warm up! so who knows...
I would have thought the fact mine fixed its self that it...
Just for information,
Driving along the other week I noticed my passenger side climate wasn't working and it was pumping out full heat even when the temp was set to low. Then the next day I noticed it was controlling the temp again! The week later it went back to not controlling the temp so I...
In the haynes manual it says:
Front upper link arm position = 81 +-2mm (taken from the flat mounting surface to the back of the ball joint)
Rear upper link arm position = 70 +-2mm (taken from the flat mounting surface to the back of the ball joint - not the rubber bump)
I presume there should be...
I couldn't get to the top arm inner bolts out when on the car so I had to persevere with removing the seized pinch bolts! Took a day per bolt! Air chisel didn't work, in the end had to cut the head off and use a nut and washers/spacers to slowly pull the bolt out, cutting sections off as it...
£20 sounds too cheap to me for a full alignment.
I bet they would just check the front wheels are parallel for that! Both axles need to be checked at the same time.
Even the OE parts are made to a tolerance plus and minus, whenever fitting new suspension parts it's always a good idea to check...
Is there any way to tell which side is affected? (I have an estate with poor radio reception which gets awful when I plug in a USB charger)
Any way to fix or do you need to buy a new antenna?
Tom.
Great read, very impressed.
I admire how you still manage to get the camera out even when things go wrong!
I often think I should photo document my jobs but when my hands are dirty and just want to finish and get a cuppa I rarely remember to get some photos. (unless it's tricky and I need to...
GM got fined $900Million for killing over 124 people and injuring 275 with faulty ignition switch!
VW potentially to get fined $18+Billion! for flouting/bending an emissions reg. It hasn't been proven yet has it? It's not even helpful lowering NOx unless you live in smog filled LA! you actually...
This tank worked out at 43.5mpg so not as bad as I thought at first but still 3-4mpg down on my usual 47mpg!
I'll have a play with the timing and see if I can improve the mpg.
Well think it's definitely worse MPG, done half a tank and only 230 miles - would normally expect getting 300 to half a tank, using consistent 50 mile duel carriageway round trip to work. I will fill up and calculate the exact MPG.
Will have a go at advancing the timing to see how that affects...
Checked mine over the weekend and was flicking between 0 and -0.55 with a warm engine.
Although running smoother with less exhaust soot than the old cam belt (which I have no idea of the torsen value) my first fuel refill worked out at 40mpg!!! so i'm hoping that's an error in my...
Thanks for that, didn't know that. I've been reading about torsion values in other forums and there seems some debate on the ideal value? I'll plug it in and see where it is. Is there an optimum for the B6? or just aim for 0.0
Tom.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.