Search results for query: *

Got this sorted :-) The hex drive was rounded off so replaced this and this only, as after a close inspection the balance shaft was not worn and with the new hex drive in place there is no play at all so it will not slip.... Brakes are working again, but still looking into this as the vacuum...

Cheers will look into this

Pagid pads all around perfect for general driving and good enough for stopping when some **** pulls in or emergency brakes, but iv noticed a slight fade once i get them really hot but then again they are not performance pads. Had some yellow stuff as mentioned above in my 3.2 A4 along with the...

Hi all, I have a much loved Audi A4 2.0 tdi sline 140bhp 2007 (BRE engine code) On my daily commute to work early morning my brake pedal went stiff and no brake force at all so had to get my hands on the handbrake to bring it to a complete stop, fortunately i was strolling along in traffic...

Agreed, but the the engine is staying cold, the lower pipe coming off the rad and leading onto the thermostat is always ice cold even after driving for a few hours the water is not circulating and the engine is luke warmish...not hot as it should be jus came back from the garage...changed the...

Iv had the car scanned no codes, apart from my parking sensors as one has given up. I assumed there is only one coolant sensor on the back of the block?...cannot find another one... Water is not circutlating around the block im now assuming my water pump is weak and looking into that..

Lol i wish it was! Its defiantly in the right way!

Blead the cooling system again still the same... It takes average time for the car to warm up to 90degrees providing the blower is off, with them on and stationary it will fall down to 60degrees but what i find strange is the heaters are blowing piping hot air all around the cabin regardless of...

Iv more or less blead the car with the process you mentiioned... but worth another try...

Change it again?..

Hi all, Problem I have is the car is taking longer than average to warm up, during this process with the blower on low and on max temp and if I'm in traffic the temp will go down back to cold. Once warm on 90degrees again if in traffic or stationary the temp will drop down again. I have...

Still no luck, checked all springs appear to be fine along witn the brakes... Have a doubt on my driveshaft's...the only thing that has slight movement/play buy would this make that clatter/rattle noise? When i twist the shaft foward and back it has approx 2mm play in both directions also when...

Brake pads have been changed recently along with the supporting clips/bracket which holds them into place, no movement when i checked...visually the spring looks fine will check again and swalder let us know of the outcome

Hi guy's & gals hope you can help, and before you say I have read all related threads and posts but still no luck I am getting a clunking/rattle noise from the passenger footwell only over uneven rough road surface and potholes not bumps. Upon research i have changed the lower control arms...

Hi This has been resolved, eventually the clutch started to slip and i got this changed as soon as. Apparantly even though the clutch was not slipping at the start as it was worn the torque was limited and there was at least a 3 second delay before you can feel the turbo come in... Has been...

Let me know how you get on pal, iv got the exact same problem, very annoying..

Thanks for the response, Have tried this today with another pipe and blew into it, moves freeley up and down

Hi all Hoping someone can help as i have not found a definate answer to this problem. Recently remapped my car 1500miles ago and it has been running at its peak... Unfortunatly over the last few days i have noticed a power loss and very recently it has a huge turbo lag, the turbo still comes...