B5nut we are talking about genuine looks headlamps - not an aftermarkets. Those lamps from your link u can buy from uk and they will be rhd but I want lamps what looks like originals.
Btw they are not so good, my mate have them and they are crap
Germany are not selling rhd drive headlamps unfortunately. I've already asked for that.
That bolt is taking all my abicious to do it that's why I will use a company on ebay who can do drl lamps for you already prepared without fitting sensors on.
I was thinking about it to my a6. I've got all the bits for this including selfleveling sensors, wires level module and a bixenon lights. I want to sell all that i buy led drl headlights. It is too much hassle with it
Hi Steve
Use this link for retrofit your lamps
https://granttiller.wordpress.com/2011/03/27/audi-a6-avant-c6-–-led-tail-light-retrofit/
You don't need any wires just a couple of minutes and vcds to code them to your car.
Ask someone from your area to help you with coding or if you are from...
I'm from Wigan area
Yes u need new cluster with full dis. Some loom for a stalk and a stalk itself.
It would be worth also to fit oil sensor in oil sump as this would give u fault on the dash.
In some cases depend what immo cluster would it be u might need new immo transponder crypto48
I'm a ASN member for a quite a long time but never bother to put my name down so now here I am:
1 - Ruffrida - B6 Avant Quattro - Wigan
2 - Tay - S4 B8 - Warrington
3 - davy1977-a4 b7sline-Runcorn
4 - dannyh S3 8L - Manchester
5 - Jim - B6 Avant TDI - Manchester
6 - AlexGSi2000 - B6 Avant TDi -...
No it is not that easy.
I've tried that what u were saying but unfortunately the frequency chip has got 434MHz where the ours is 433
Soldering onto new (old 8l board) did not give u nothing. It just won't let u adapt that key. So I've decided to go to electrician who build new board for 8P...
On top of the unit u have two metal clips (one for each side)
When u pull your radio unit off u will be able to put small screwdriver to push it out from inside. Or just use some muscle and just push:)
U need to get unit out then unscrew front panel of it. It has got a couple silver very small torx bolts. Then unscrew electrical circuit again same bolts. At the end push out buttons from backpanel. Fitting in reverse order
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.