I bought a used 8P0035193G and istalled it with the OEM rear view camera kit.
Everything works fine but now i would like to install the OEM bluetooth kit.
Found this on the internet...
Well.
just installed a new turbo,full 80mm exhaust, new 90mm intake, and waiting for the second meth injector with the 9.5 lt tank from snow performance.
Huge difference in sound and times an the road even without finetuning the ECU.
Exhaust very silent and almost without any drone due to the...
Oil piston rings.............
Classic German malfunction..............:joycat::joycat:
New pistons rods if the dealership covers it.....and if the engine block is is good conditon....
It has to do with the center gap of the sachs disc and the input shaft of the gearbox....they don't mach exactly ..... and as a result you have noise at idle and ( for me personally) changes above 6500 were a gamble.....sometime ok, sometime 2nd to 3rd was a complete failure...
So i installed...
This week was a bit handfull.......
Installed snow performance stg2 / iboost with all the solenoid valves for controlling the meth kit.
Had the ECU remmaped for the big turbo........K04 RS550
On the street it made 8.77 for 100-200 with 1480 kgr ( with full tank )+95 kgr me in it.
boost is at...
Had mine with drop in the HPFP from 170 to 80 bar from 4000 to 6000 rpms..logged it many times......changed everything low pressure pump, high pressure pump, O2 sensor...and still the problem was there.....misfires at the same range of rpms....I had another owner of a 2.0 tsi S3 with the same...
Well you should check the fuel pressure sensor.
https://www.vagparts.com.au/products/06j906054c-fuel-pressure-sensor
Very cheap and sometimes doesn't give a fault on the ECU
Very well done...but the RNS-E seller informed me that the 8P0035193G cannot be connected properly with an RVC.
Don't know if the hardware has the N.C. or the RFSL
Hi everyone.
I have just bought an RNS-E 8P0035193G from ebay.
My concern while reading the ''how to'' for connecting rear view camera is that there is a diffculty connecting properly an RVC?
Am i correct?
and if that's the case can someone give me an advice about connectivity for a RVC kit?
The best choice indeed.....is yours 19'' or 18''?
Mine 19'' and I had instant rubbing with the rims on at the back....19*8.5 ET44.
Removed the screw from the bumber at the back an trimmed the plastic there very carefully and seems ok now.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.