You don't need a press to change the front bearing on a B7, it's held in by a few bolts. So undo centre drive shaft bolt, lower arm (to get shaft out) and then you can see the bolts holding it in place
About this time last year i replaced the chain/tensioner on my engine because of the very common rattle of the tensioner failing. It's all been good until last week when i noticed the noise starting to come back :(
Has anyone else had issues this early after doing this job?
I used genuine parts...
Thanks for the replies guys.. checked the driver door harness and found that i had a live missing. Re checked the fuse that fed this wire and found a break in the spade of the fuse and not the fuse wire. so when i looked at the fuse in the first place it looked ok.
So replaced fuse and...
Hi, i have two fault codes stored in the conv ECU,
01811 voltage for door controller driver side (j386) faulty
01812 voltage for door controller pass side faulty
central locking, electric mirrors and the iluminations for both the front doors don't work.
Fuses are all O.K.
Has anyone had an...
Hi, just had one with the exact same symptoms as this today. No low down power, jurking under load and no faults stored. Turned out to be a faulty air mass, fitted new one and the car is perfect. Hope this helps
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.