Yep Quattro is AWD with 40% front 60% rear which can make the car kick out but get pulled back into line with the front pulling.
Not sure if power changes front to rear except in RS models or if it just cut power to the wheel which is spinning?
I done my 2012 firmware which had to be done twice as I was advised I couldn't do it in one hop and then put 2016 maps on.
I have 3G+ with Googlemaps but not bose system.
Thanks I will be showing the garage this.
I bought the car with 47k on it with FASH.
I got it done about 50k mark when i realised it had to be done as Audi Preston girl not sure if done or not?? So to be on the safe side i got it done.. BAD MOVE as it turns out.
May be a coinsidance but no...
I have been getting the same issue in my 2012 A7.
This started 10 miles after gearbox service.
Garage saying its due to my map.
Car has been mapped for about 5 months no issues until service.
Just new here too.
I got an APR map done on mines as i had a superchip on my A5.
My car was the Quattro 245 version & had 260 from start so 15 better off the mark.
Stage 1 with K&N filter got me 315bhp 630nm.
Hope this helps and money well spents.
Pulls good
Long and hard but very smooth.
A5 &...
Hi guys i'm new to the A7 group.
I just sold my Phantom Black 3.0tdi A5 and now got a (245) 3.0tdi Ibis white A7 Quattro. Lots of gadgets.
Had the car now for about 4 weeks.
Been busy.
Car clayed, machine polished etc etc.
New Brake pads.
New wipers.
Calipers painted cosmos black and Sline decs...
Just finished it 2 mins ago and looking good..My advice after much ****** about is..Take the motor off with the 3 torex bolts and support bracket..i used grips as no access.Took of pipe from air filter just 2 jubilee clips but left wiring on. Also left the wiring on motor.I took off bottom ball...
Direwolf congrats on the new car. I know the coupe boot is big enough gor twin pram as we have 17mth old twins. But wife sold her ST3 for a touran does the job well.
ps
sleep is for lighweights :-)
Guys got a hold of vcds and reset all codes.eml came back and after looking about i found out the linkage arm for the motors for the swirl flaps are a common cause due to wear being as how audi put plastic ones in.
i have ordered replacement ones from ebay oem parts as i also gound out if you...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.