Hello,
I'm looking for rear mud guards for my a3 sline 2014 5 door.
I've seen online there's different part numbers for the rear guards for hatch back and the sport back.
Is that correct? It seems crazy they don't fit each other.
Good eveing,
I've been off the forum for a long time but I'm returning having bought a 2013/14 Sline Sportback.
I can't help but feel it sits too high. I'm trying to work out if it's normal, spec'd with higher suspension or if it may have been replaced with higher springs.
I'm tempted to order...
Good Evening,
I've finally got round to buying a new car which has the CAYC engine fitted. I noticed the other day that the engine was a little lumpy whilst cold and ticking over.
Tonight I've popped out and taken 2 readings:
Readings when cold:
IDE00365-ENG99400 Injection amount deviation...
You can easily pull off the hub from the bearing. Them i used a slide hammer screwed into the bearing carrier to pull the carrier away from the upright.
Yeah the pulleys were fully turned over.
Its driving nicely but instead of 48+mpg it's returning low 40s.
How should the measuring block react? Mine seems really slow and takes an age to get up to number.
Reving the car doesn't make it flick but when it's started cold the torsion isn't on 0.00 so I'm assuming it is correct?
Which way do you turn the rear cam to reduce l/h?
I can't get mine below 0.62 l/h
Finished work today and it was idling like a pig and it stunk. Rev when standing and it would puff smoke.
Got it warm and plugged in the laptop. Torsion was at 1.49 and l/h was 0.65
Adjusted the torsion to bang on 0.00.
Adjusted the rear cam and it already feels better but not had a chance to...
Cheers Everyone. I'll let it settle in over the next few days then I'll have a look. So it's just a matter or letting the car run until it's settled on a number. I can do that.
Thank you.
Good evening,
I've just done the cambelt on my car. All gone smoothly and I've got the torsion value to 0.35 which seems nice to drive. I read online about adjusting the rear cams.
I've looked at channel 15 which has litres per hour. As i start it up. Its really low like 0.035 low. Then it...
Good Afternoon,
I replaced the spring on my other halfs A3 last year after it snapped. After I replaced it, I noticed there was a creaking noise.
I thought it was the strut top bearing as the broken spring had jammed into the bearing. So I replaced the top bearing and top mount a couple of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.