Just used the template and instructions. If it's wrong it wrong but from drivers position it doesn't bother me either.
You have plenty of volts to play with then.
I'm looking at the indicators next, like yours - all the best my friend
The template supplied has cut outs and due to the matrix lights sensor, the camera is further away, i.e. lower down the windscreen to avoid interference.
If the car is left unattended for a long time, the camera is likely to shut down anyway due to battery drain. This is likely o be the case...
I have fitted one of these myself and am very satisfied with it. Parking mode with radar works well and has a built in battery monitor as standard so the battery isn't discharged, thus shouldn't void your battery warranty as other posts I've seen have. To me it is a fit and forget item unless...
@Schizophonic
I got it from here
It was a self install, time consuming as I was also fitting my reverse camera too, but same panels removed etc so overall not too bad. I allowed a day!
It basically wires into a live fuse and a switched fuse (same as the other makes). No other connections to...
@S32B I have Matrix Led head lights so the specific template used positioned it lower. Any higher and the camera would interfere with the Light sensor in the mirror housing.
I’m a stupid stupid stupid boy!!! Each positive lead from the UTR camera splits into two fly leads. You remove the pin from the fuse board and then insert one of the fly leads into that position on the fuse board and then insert the original wire into a connect like the picture attached (if that...
I'm a bit perplexed lol. Yesterday when I reconnected battery to move the car the HBA errors weren't there. I disconnected battery this morning and when reconnected they were there. I can't even check coding as I can't read the module
In the fitting instructions there were 3 templates each with 3 fitting positions. If the camera were to impinge on the HBA would that through an error.
Thanks
Thanks @DJAlix The UTR camera sits alone and basically has 3 wires, a ground, connection to fuse 34 and fuse 4. (presumably constant live and switched live) - no connection to mirror wiring at all.
I'll remove the Navigation from Can Gateway, although I didn't add it in the first place!
With...
Thanks Nigel,
Rear camera will need calibrating and I will get that done when time allows.
The Auto HVAC did clear but has come back on again after a drive. Would the aircon need to be on to clear this?
I can't get my head round the HBA and the Navigation! On a Golf forum on a golf the...
Hi all,
I've spent the past couple days installing my reversing camera and also the new Audi UTR camer. All has gone well and working.
However, when I reconnected the battery, besides the usual error codes, I've got additional ones. I've cleared all codes and this is what I've been left with...
I've had a few requests for pictures, see following thread post no. 9 - it works when viewing the forum in Google chrome
http://www.audi-sport.net/xf/threads/glove-box-light-retro-fit.363977/#post-3221036
Cheers to @MarkWizard
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.