Search results for query: *

It does just seem too weird to be true :) Seems to be working reasonably reliably now (when an iPod is there!) but the sound quality is shockingly bad with my Nokia 8600 Luna... I'll try another phone and report back. As far as wiring goes.. I was under the impression that the A4 '04 plate...

No. The Pairing section of the menu isn't selectable even when the phone is paired. However, after following some advice from a diff. forum I got hold of an iPod Full Speed lead, connected my iPod to the BT box and the BT box to the HU as normal. (rather than iPod connected via USB to the HU)...

and now you've posted that I've remembered that this one is connected already.. apologies.. I'll double check that it's firm etc

I suppose the question is.. are the RCAs for the sub enough or should it also be connected to a speaker out too...

so.... appears the sub isn't on at all.. Could it be wired incorrectly? Here's what I've got.. The red harness is connected to the sub out RCAs on the HU and nothing else. The wires that where coming out of the amp that where to the speakers I cut and taped up the amp ends and connected...

Cheers Andy, I'll jack up the sub volume on the HU, the sounds still pretty good and I think I'l save the pennies... may as well upgrade the amp and sub rather than spend mney after bad Thanks again, Now to phone Alpine about my Bluetooth ;)

So I spent the day running two cables from HU to cut speaker cables and it's a hell of an improvment! No hiss and greater volume and clarity! Spot on.. cheers Andy! I've left the red harness in place for the RCAs to sub but I'm not 100% that's working.... will check tomorrow... I got too...

So do I actually need to run new wires from the HU? Couldn't I re-use the existing rear speaker wiring that currently goes into the amp? If I take the rear speaker wires that are currently being fed from a non amped output on the HU, hooked those up to an amped source (effectively swapping...

hi andy, thanks for the reply (judging from all the replies in the other threads you're the guru :salute: ) So just to be clear... 1. I run two new speaker cables from the HU's (+L/-L) and (+R/-R) 2. I cut the two existing speaker cables that where feeding the amps L+R and insulate the wires...

Hi guys, Apologies for the long post but I hope this can collate some common questions with some definitive answers :icon_thumright: So I've just had an Alpine iDA-X100 installed with the Alpine KCE-350BT Bluetooth phone kit and I have a few niggling problems that other members seem to have...