Ok, so this is where I'm at; I connected the K-Line pin from the original blue connector to the Dension blue connector and rescanned with VCDS - still no joy :-(
The K-Line cable comes originally from the bunch of cables linked to the green connector. I dug back through evernote to find the...
Hi, I'm after some help with a problem that's driving me nuts:
TL;DR - I can't scan my RNS-E with VCDS with Dension Gateway Bluetooth unit installed and the bass is really boomy leading me to think the Bose pin is in the wrong place.
The longer version...
2007 Audi A4 Cab with Bose, MFSW, Audi...
Just reading round the net - it seems that I need to measure it with the roof down not up - so perhaps this explains it. The residue is still a little concerning though, unless it's been serviced previously and someone 'missed' when topping it up?
looking for some help with leak from Cabriolet roof. Water coming in at front driver's side corner where it meets the door post. Checked that roof is properly locking and lubricated latches. Is there anything anyone can suggest?
I had the same thing on my previous B6 Cab. As Willf92 said -...
Hi, my A4 B7 seems to be suffering from the same problem. I've just been following your awesome instructions to get to the motor. I've got access to it but have noticed theres a residue in the bay below it. Am wondering if perhaps some of the hydraulic fluid has leaked at some point (it looks...
Hi, I've been considering upgrading the BNS 5.0 head unit in my Audi A4 B7 with an RNS-E unit. The current system has a 6Disk CD Multichanger in the glove and factory fit bluetooth handsfree as well as a phone prep in the armrest.
I was wondering whether:-
- Is the Bluetooth built into the...
Does water drip in when parked and less of an issue when driving? Mine did this on passenger side, if it's the same problem it's fairly simple to sort: There are two draining tubes that run through the middle of the rubber seal that runs down the windscreen pillar. The get blocked up and this...
Hi Blackpool1974, I've got the same problem with my compartment. How did you go about doing this? I was looking at it today and trying to figure out whether I could lift the whole compartment assembly out and do it but couldn't figure it out. Did you do it in place? Any tips much...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.