Search results for query: *

it could however be any of the Devices attached to the Drive belt as moving the steering adjusts the load on the belt there four making the pitch change it may be the belt is to tight causing bearings to be a little noisy and as the PAS pumps seem reasoabally Reliable on the S3 i would think the...

White S3's Rule!!

nope defo LCR calipers checked the part numbers as Had to confirm these with Bill for hoses and pads and they are 100% LCR Calipers so i have now sent the Mounts to my machinist after Will20vt from E38 helped me out with the lone of some hubs

Try Bill at http://www.badger5.co.uk/

you can get EBC turbo Groved 323mm x28mm SEAT Leon Cupra R disc for £160 a Pair from Ebayshop RiceRocketUk you will have to message him about them as they do not put them up on ebay but he does stock them and the service was great!

I have the 323mm setup for my car and these about 5mm too tall for getting the pad on the disc face correctly so 328mm most likely will get some better measurments this weekend when i measure it all up and got to my engineering shop for prices

hi can any of you provide me with measurement from the hub face(Drive flange) to the caliper carrier mounting point on the hub ?

From what i can work out htis is for 330mm Disc's and is for mounting the porsche caliper to an Audi S3 hub so with a little adaptation you should be able to mock one up in wood to test fit it then get some one to make some up for you

I have a good machinist just need to check the sanity in my measurments and not to wreck what I have already Measure twice cut once as they say

so far these mounts have cost me £90 and I cant just throw that away and spend a further £120 each on Genuine Brackets from seat And Brembo was a total loss cause they won't supply just that part its a kit or nothing

i want to Modify the Mount not the caliper Just to clarify

Ok Here we go this is what i have so far I payed for some brackets off a forum member and were told they would Fit the LCR setup but you guessed it they dont! I bolted the 323mm Disk up to the Hub then put the carrier on the Hub this bit is fine but when i put the caliper over the disc it...

as anyone got a Brembo kit they havent fitted yet Need to check some measurements on the Carriers as my setup didn't come with any Measurments needed 1.) distance from centre of hub mounting bolt to caliper mounting face of bracket 2.) distance from hub mounting face to centre of...

My car has (Aps) Audibale Parking sensors fitted as an option form the Factory and the Beep comes from the speaker thing above the ashtray as far as i can tell uses the same beep as when you put the car in Reverse(this may not happen on a non APS equipped car)