Ace if you go in the hvac module, the measuring blocks you can see what each of the channels is set at. Then go tot the adaption tab and got to the channel 24, wt & 26 then set a new figure.
Sent from my iPad using Tapatalk
Yes the tab should be right down in the slot and the pitch bolt should just miss the curved bit. I normally remove the hub to get the shock properly seated
Sent from my iPad using Tapatalk
I run 340 j hooks on the front and the pads cover the whole disc no lip as it wears and less sprung weight.
I previously had ds2500 pads but now minted 1144s, no where nearly as good as the ds, will go back to them next. The mintex don’t seem to have much bite. Rears are standard j hook size...
Ordered and fitted the new BCS sport centre section
Pity I did just before lockdown!! With limited driving, I can’t help but turn off the music and open the windows
Great sounding piece of kit, really snarly, sporty sound and not louder than the original power valve section just a better...
These guys at Jw autotrim could help you out https://m.facebook.com/JWAutoTrim/photos/pcb.1016682518671804/1016682075338515/?type=3&source=49
Sent from my iPad using Tapatalk
Fitted the new BCS centre section The assembly will also allow the S3 to achieve above 390 bhp with correct mapping and additional hardware.
Pity Rtech have now shut up shop, so can’t get my map tweaked [emoji24]
Sent from my iPad using Tapatalk
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.