Phatvoice is a great program for altering pronunciation with a bit of time spent customising the Regexp you can get it to pronounce anything correctly.
You have to use media manager / music manager to create the tags in the first place then use Phatvoice to alter them.
The voice I am using is...
I converted mine to run with a Kenwood head unit.
To do this you need a new cable and to re-flash the Phatnoise to run Kenwood firmware.
Also Kenwood head units made 2008 onwards require an additional Kenwood switch box (KCA-S220A) to be used, pre 2008 Kenwood head units do not require the...
The Audi aerial lead already in your car should look like this.
The above Audi aerial from your car will plug into this end of the lead below.
And this end below should plug into the back of your head unit .
The blue wire connects to a switched live from the new head unit...
If you set them up right[standard settings are cr@p] and run them in, the Panasonics do not suffer screen burn (some short image retention can happen from a long playing static game screen but that goes after a few seconds) .
I have a 42 Panasonic plasma, xbox 360 combination + a nine year...
if E=mc2 then wherever there is mass there is energy and wherever there is energy there is mass.
Light has momentum it can never be at rest but theoretically if light is trapped in a box with perfect mirrors so the photons are continually reflected back and forth in both directions...
During the early nineties when I came back from living in the states I brought my Gul radar detector back with me.
The thing was a bit over sensitive & it always went ballistic every time I approached traffic lights, temporary or fixed with a sensor box attached (middle or top), it did...
Its not actually a heat sink as dunk says its just cosmetic. Audi had to make it the same width as the OME cd changer to fit in the same hole.
this is a nice conversion.
The USA ones are exactly the same apart from the power supply for the usb docking station. You can buy a replacement from Maplin.
Link about it here.
http://www.audi-sport.net/vb/showthread.php?t=26250&highlight=psu
The wires of the CD cable just push in the connector block at the back...
You have to buy a new lid on the B6. Just done this for mine £40 from you local Audi dealer part number V8E0 864 245 A1 7C (N/STK cover) . You can buy a repair kit but it does not work on the B6 type IIRC its for the A3.
Edited to add: End of part number varies with inertia trim colour.
First bike Yamaha TY 80
First bike I bought CR 250
I raced most of my life so countless MX and track bikes
My road bike history
Honda XL 100
Honda MTX 200
CBR 600
Fireblade
VTR 1000
I would love another MTX200.
Audi did a TSB bulletin for this problem.
Quote This condition may occur while driving (especially on rough road) or in cold weather when opening/closing the doors.
This condition may be corrected by increasing radio volume.
This link explains it better...
It just pulls out.
Remove the radio from above and push the control unit from the rear it will just push out.
If you have a single din radio (concert II) then you can get your fingers underneath the control unit and pull out it out without removing the radio.
The only way to be certain is a VAG com scan to show up any faults.
But a faulty brake pedal switch can cause a loss in power.
The switch is linked to the engine management & can put the car in limp home mode or just confuse the ESP system as to your intentions (accelerating whilst it...
Straight answer yes. I did the opposite I removed my sliver trim from my concert II to put on my Kenwood.
But I have no idea if a concert II will fit in a B5 slot, also you will have to get a canbus emulator to make to make the concert II work properly with the B5.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.