Separate names with a comma.
I have the 2.5 quattro goes very well munches up the miles do 150 miles aday and been very reable would have another one without thinking twice about...
They are just crazy. I drive 150 miles aday to work and back so i need to fill up every 3 days wet to morrisons que was was about 20 cars long. so i...
NICE CAR WELCOME TO THE SITE
I would have a b6 drive great alot better than the older cars b5 better inside if you do a lot of miles.
Anyone able to help?
Can anyone help i'm looking for a power supply unit for a audi quattro tdi 2.5 2001 b6 model .This is the small unit behind the dash at the rear of...
WD40 and rock it from side to side while pulling up ward or give it a light tap with a mallet white pulling it up
Up date cannot find the cause .I have changed the switch with a brand new one. Switch pin 6 is 12v+ pin3 and pin 4 are earth pin 2 does not have...
i had this problem i had a 777 error it was the accellerator pedal replaced the pedel and it went again pedel got replaced at aud'is cost
The only power i have on the switch pin is 12v across pins 3 and 6 the reast are dead
Does anyone have a wiring digram for this car that i can look at ? It might help me find the problem
i had this it is the pedal £70 from audi you should be able to fit your self
i have most of the dash out but cant find the relay had my hand up there and had a look were i could see at the back of the clocks only looks like...
Can anyone help?
i would go to a meet if there is one near by
I have cleaned out the indicator switch this has not fixed the problem. Does anyone know where the relay is or have a wiring diagram?
:banghead: i have tried looking for a relay not in back of switch like earlier models dont have a wiring diagram or know were the relay could be...
Indicators work ok just the hazard light switch is not working
Parking lights work ok with key out indicators work fine when used no excess clicking or sticking
can't find a relay in back of the switch opened up the back only a small board that has the switch on it and the leds the it uses are soldered onto