Q7 Q7 Transmission Cooler valve fault

Cockney Boy

Cockney Boy

Registered User
Joined
Nov 26, 2007
Messages
482
Reaction score
6
Points
18
Location
Aylesbury, Buckinghamshire, UK
Hi Folks,

Got a fult code pop up on the Q7 a few days ago. Its says that my Transmision Cooler valve is short to ground. (Fault code P2754)

I have tralled the web for hours with no joy. we also spend a good hour under the car looking for any valve of sens or relating to the oil cooling circuit.

Address 02: Auto Trans (J217) Labels: 0C8-927-750.clb
Part No SW: 0C8 927 750 AE HW: 0C8 927 750 AE
Component: AL1000 AISIN 001 1815
Serial number:
Coding: 001578
Shop #: WSC 31414 790 00001
ASAM Dataset: EV_TCMAL991031 001001
ROD: EV_TCMAL991031_001.rod
VCID: 6FE6642EB6D83E3A55-803A

1 Fault Found:
12754 - Valve for Transmission Fluid Cooler
P2754 00 [143] - Short to GND
MIL ON - Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 2
Reset counter: 44

Engine speed: 0.0 /min
Transmission input speed: 0 /min
Transmission output speed: 0 /min
Engine torque: -76 Nm
Transmission fluid temperature: 10 ∞C
Accelerator position: 0.0 %
Clutch status: Open
Clutch status: Open
Clutch status: Open
Clutch status: Open
Clutch status: Open
Clutch status: Open
Clutch status: Open
EOP failure status: Normalcy
EOP target revolution: 0 /min
EOP actual revolution: 65279 /min
Engine Speed signal Current: 65279 /min
EOP failure status with EOP without HV: Motor normal stop
EOP target current: 65278 mA

Any ideas on where it could be?

Rich
 
audi upgrades
Hi. What was the problem with your car?
I have the same problem with my car.
 
I've taken apart all the harness conection to the gear box and sprayed them and still the error code. The temp sensor for the gear box is located on top of the gear box. If i delete the fault code when the car is running it dont come back but when i start the engine it will.
 
Hi,
I believe it might be too late but check this solenoid: Component 27 on the diagram.
The code refers to the transmission cooling circuit but it does not state the temperature of the ATF. It is antifreeze control solenoid for the transmission cooling circuit. Part number 4H0121671D.
Audi released a technical bulletin for the fault of this component, but usually it comes up with the code 2753 or 2755.
Untitled
 
mattq7 said:
I've taken apart all the harness connection to the gear box and sprayed them and still the error code. The temp sensor for the gear box is located on top of the gear box. If i delete the fault code when the car is running it dont come back but when i start the engine it will.
Click to expand...
I have a 2012 8 Speed Q7 , and got the errorr P2754 for a year . experiencing same as you . when I clear the fault the Auto start stop and Cruse control workes . when the engine lite come back with Gearbox malfunction both Cruse and Start stap function will be disabled as well , at the same time gear box performance will be limited ... .. They suggest to replace the sensor board in the gearbox , I dont want to touch the gear box unless I am 100% sure its the right foult
 
You must log in or register to reply here.

Similar threads

D
Q7 Fault code P2754 transmission fluid cooler control valve
Replies
0
Views
9K
Damian fletcher
D
A
Q7 Help with sourcing a Q7 Transmission Valve Body
Replies
0
Views
1K
andri86
A
NIKO51
Q7 Q7 Steering Fault
Replies
1
Views
1K
aj84
A
2
Q7 Please Help: 2015 Q7 PCV Valve
Replies
4
Views
5K
2015Q7
2
Jake1
Q7 Q7 Pre Sense fault
Replies
2
Views
1K
Jake1
Jake1
Top
Back