Folks, with my 2001 S3, last week I went thru several speed bumps, and one of them I went a little too fast. So I ripped 2 out of 4 plastic mount of my front bumper bar. So now I need to drill a small hole on the bumper bar and tight it up using cable tight. Unless new repair is required to glue another strip.
Because of above issue, I raised the front to avoid further consequences. Now its 3 finger high from the tyre to wheel guard, and back remained the same which is 2 finger high. I also checked with a new A1-lucky at work, its a stock, has 4 finger high on both front and back.
My question is my car now its 3 in the front and 2 in the back IS THIS OK for best traction settings????
Thanks again.
Because of above issue, I raised the front to avoid further consequences. Now its 3 finger high from the tyre to wheel guard, and back remained the same which is 2 finger high. I also checked with a new A1-lucky at work, its a stock, has 4 finger high on both front and back.
My question is my car now its 3 in the front and 2 in the back IS THIS OK for best traction settings????
Thanks again.
