Removing rear valance!
- Thread starter Mindak
- Start date
Undo the screws from either end of the valance and then just press out the clips from behind, it is fairly flexible.
It's a little trickier in reverse but just make sure you line one end up first and work them all the way in as you go otherwise it'll appear short.
This is all assuming you already have the bumper off!
If not, take the bumper off!!!
It's a little trickier in reverse but just make sure you line one end up first and work them all the way in as you go otherwise it'll appear short.
This is all assuming you already have the bumper off!
If not, take the bumper off!!!
Even if you could, its only a 20 min job to take off the bumper.
Remove bumper screws from both wheelarches
Remove both outer rear lights and then screws hidden behind
Remove the 2 main bumper nuts from inside the boot
Pull bumper out from rear wings
Job done!
Remove bumper screws from both wheelarches
Remove both outer rear lights and then screws hidden behind
Remove the 2 main bumper nuts from inside the boot
Pull bumper out from rear wings
Job done!
left mine on, arch liner will not fit after it and mines is 5mm out each side but looked at another and it was the same.
- Joined
- Feb 13, 2015
- Messages
- 54
- Reaction score
- 9
- Points
- 8
