boost gauge? where is the best place to run hose??
- Thread starter epox
- Start date
Freeman_1986
Registered User
If it's going into the drivers side vent, take the side panel off the dash and remove the fuse board. There is a grommet at the back that you can push the tube through and will come out under the scuttle panel.
I made a new hole to go into the engine bay and run it through a new rubber grommet and into the pipe out that comes out of the top on the DV.
I made a new hole to go into the engine bay and run it through a new rubber grommet and into the pipe out that comes out of the top on the DV.
I ran my hose down the same grommet thats already there, just cut away a little at it to fit new hose down. Then just took one of the clips from the fuse board cover off and ran the hose through that into the vent 
- Joined
- Sep 14, 2008
- Messages
- 24,836
- Reaction score
- 6,076
- Points
- 113
- Location
- Wibbleton
- Website
- www.tuffty.co.uk
Handbrake cable into the engine bay? thats a new one...
As mentioned... grommet by pollen filter, there is one behind the pollen filter too or (as I did) drill a hole in the plastic cover under the wiper motor mech
There are a few pics in my build thread of course
<tuffty/>
As mentioned... grommet by pollen filter, there is one behind the pollen filter too or (as I did) drill a hole in the plastic cover under the wiper motor mech
There are a few pics in my build thread of course
<tuffty/>
