Recent content by yahyar

http://distilleryimage9.instagram.com/f9aa0992707111e1989612313815112c_7.jpg finally got a pic

car on 19 r8 v-10 reps and h&r coils, falken 225/35/19's

225/35 not working - still rubbing. suggestions?

aye aye captaiN8! will report on it next week! fingers crossed

Thanks for the help so far... Here in SA we are very limited: the rim only available locally in et45. pity for me, but apparently it should be fine according to just about everyone? my car is probably just too damn low. I want to try the 225/25 to see. i should also ask the shop to raise the...

hi guys got a set of 19" r8 v10 replicas. i was advised they would fit. test fitted with 235/35/19 huge rubbing issue at the back. Will 225/25/19 be any better? or will i continue to suffer rubbing due to ET45 offset? it's a shame cos i really like the look

ferris, did audi sort this out for you? can you post a picture of before and after? audi centre cape town have refused to fix this for me and it is now 8 months later!!

I had a similiar problem when i got my MY09 s3. the revs would search up till 2000rpm. vagcom did show a fault, but audi couldnt fix the problem immediately. it turns out it was air leak as the vacuum pipe wasnt properly connected, according to the technician this was only discovered after audi...

tobycruse has the exact spec ur after. i'll admit im too lazy to go and look for the post, but search all threads by him and it'll pop up.

like i said, use it, dont use it no need to get your panties in a knot Mattandrew: in the two cases of autotech failure both of the pumps ceased. not the cam followers. maybe its down to improper installation? I didn't get the 3rd degree on it but in the short amount of time both of them were...

i personally know of two guys with autotech internals which have failed. use it, dont use it

FLAWLESS VICTORY!!!

I found a PIAA H11 4700K on ebay. Perfect match with the 2009 S3 headlights Mine were from cargym.com Hope this helps

I managed to solve this just by turning the plastic tabs on the headlamp units under the bonnet. All this did was raise the level of the beams to a satisfactory height Other people have had DTCs thrown doing this, so I consider myself lucky. I checked the thread on VWvortex and the posts were...

Hi I just got my car on h&r coilovers and just realised that while driving at night, my xenons point down and have seriously diminished range since changing the suspension. i have read up about levelling sensors not being aligned on the suspension, but i can only go back to the suspension...