Recent content by S321BAM

Morning all..... Friend at work has a Bam engine tt, he has a strange problem with the water temp. Engine gets up to temp then creeps up to 100 and slowly drops back down. This happens when the car is in motion as well as at a stand still. He has replaced thermostat and water pump and it...

Bam engine, so yes wideband

Got the wmi fitted and up and running this weekend, can definitely tell when I kicks in. Would it need to be set up properly on on a rolling road, or can this be achieved by logging on a quiet road, if so what do I need to be looking for? Clueless about logging but have a friend who can.

Might be worth buying a service kit for the diverted valve, presume it's probably a 007p.......made of a world of difference when I did mine, can pick them up for about £10

Thanks again Bill

Just about there with the install, doing an hour here and there in the evenings, ah v1fmic now with 60mm pipework. Car has stage 2 revo map on it until I go custom...... What pressure is a good starting to point to set the pressure switch at.....was thinking 15psI, but that's just a guess if...

The kit did not come with a check valve, is it recommended to have 1 as well as the solenoid?

Thanks Steve I am swaying towards putting it in the boot, have been put off buy the car being the family car with a very small boot. Common sense tells me that the solenoid valve should be fitted close to the nozzle rather than back in the boot near the pump

Thanks Bill...... Just been doing a bit of recon in the engine bay......where's the best place to put the relay? Is there enough room to fit the pump behind the bumper by the screen wash bottle where the side mount used to be? Want to be as prepared as possible before I start as I am modding...

Hi guys, After purchasing wmi base kit from devils own in October, im finally going to fit it! hopefully before GTI international! Quick question.......where is the best or common place to tee in the boost control switch? I have a BAM engine Thanks in advance Chris

Planning on fitting wmi soon, got d.o base kit, where is best to fit the pressure switch?

Last minute, but meeting at exeter services at 7, top of main car park if anyone from sw fancys driving up with us

Cat back exhaust, already have 3" down pipe and sport cat

Evening all, looking In to having a custom exhaust made soon, got the option of 2.5 or 3" diameter. I am planning on going bbt hybrid k04 at some point. Is there any advantage going for 3" over 2.5" didnt think it was necessary unless I went big turbo, and ideally want to keep the noise to a...

Forget that just used the link provided!