Recent content by roman3000

Its a fairly simple job Undo the wheel and jack BOTH sides of the car up when changing the cv boot/joint or you wont be able to get the cv joint back into its socket in the wheel hub. 1. Undo the bolt that holds the cv joint in place 2. Undo the 3 ball joint nuts and remove from the wheel hub...

Could be the turbo vains sticking since your getting very similar symptoms, common problem on these cars.

AUDI RNS-E adapter A3 A4 A6 Diversity antenna 0141 | eBay this is what you need.

Maybe check your wheel allignment?

Yeah keep this thread updated.

Well then what about connecting it to one of the can bus wires, so it knows when the unit is on. I had this unit installed in my car Nigel, it charged the ipod when it was on and stopped when the rnse was tuned off. I just cant remember which wires i conneced it to, it just seems a lot of fuss...

Doesn't the unit stay on for a few minutes after you pull the key out though? Im sure it does. It take around 2 mins for it to turn off. It just seems a lot of work to get it working.

D: Power Connector 9 - CAN-H (CANbus High signal) 10 - CAN-L (CANbus Low signal) 11 - TEL-Mute (Telephone mute connection) 12 - Kl.31 (Primary ground connection) 13 - U14 ST DSP (Radio On) (Provides a switched ignition-out source to turn on rear amplifier (bose too) or "remote" lead for an...

I never ran it to the fuse box, just connected it to one of the the quadlock wires. Did the radio on wire not work (13)?

Just pull the trim off, its on clips that look like this <> so its pretty hard to pull off at first. Be carefull with the pillar speaker its connected to the plastic cover, if you get the plastic off you can remove the speaker from it, pretty difficlut to remove the cover but if you brake it...

You might be thinking of engine collant which requires a specific audi one G12 i believe. But for washer fluid use what you want.

Have you even been on ebay? These look pretty nice Audi Carbon Fibre Mirror Covers A3 8P, A4 B6 B7, A6 C6 | eBay

If the light isn't on yet then no need to replace it yet, but since its picked up the fault when you scanned it then you will need to replace it soon. Maybe buy the part and replace it when the light comes on. Also it shouldnt judder at all when turning off, mine didnt judder alot but when i...

LOL why did you pay £300, GSF do it for £200, its the exact same part.

YETI - RS pedals for manual transmission - RHD : superskoda.com They look the same, but the price is the same too. Someone should ask the Skoda parts department for their price.