Some of you may remember me as the bloke with the grey A4, RS6 grill, 19" Kahns, tints and more LEDs than you can throw a stick at. I'm also renowned for illegal numberplates and a few BRD engine problems.
These have included 2 failed injectors, flywheel, clutch, oil pump balance shaft and...
Here's a couple of versions I've tried over the years...... http://www.audi-sport.net/vb/audi-s4-a4-a4-cab-b7-chassis/125115-those-thinking-drls-fog-grill-mods-heres-some-i-tried-earlier.html
I'm currently using this 'OEM style' Hella Dayline lamps - custom fitted into my fog surrounds.
Just linking to this thread and saw the outstanding question! Sorry!
They're just 5mm std LEDs hooked up to individual resistors (for 12v) - mounted into the rear of 5mm perspex - which was then slotted into 5mm slots which I cut into the fog surround horizontals.
It's a bit more complicated...
You can legally make short plates on your reg - the legality is all about letter size and spacing...not plate size.
I've 'downscaled' my plates, they're both currently 410mm x 90mm (standard is 510mm x 110mm).......shows off the grill nicely.
Welcome to the RS6 grill club! :applaus:
Looks good, althought I would put a smaller plate on the front to accentuate the grill........what am I walking about, I did!!!
Xenon is just a gas, that is often used in halogen bulbs..... So i presume you mean HID bulbs?
These lamps will be designed to use a halogen lamp in the dipped beam, and a separate lamp in the 'inner' headlight - likely to be the same halogen figment as a standard oem (non HID) headlight...
Some time ago my green side light bit didnt illuminate.... Audi replaced the whole switch, under warranty í ½í±.
Seems to me that the led has failed í ½í¸³
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.