Recent content by rhinopower

Out of interest did you have this issue after having the ea189 fix? Has the car been fine since ecu replacement?

Used the form to add myself again with my new cable, not sure why i had been removed before when i had my key-usb cable? The form is bugging out at the moment so not sure if it has worked.

I've got the nefmoto software, and my mate has an MPPS clone too

The immo is all coded correctly so presumable that part doesnt need flashing?

Sorry to bump an old topic, im replacing a damaged ecu, same part and hardware numbers, but the bosch software numbers are different. I was going to reflash the new ecu with the old ecu's tune file. Will it work?

That's at a local indi. The adjusters are £370 each plus vat, but, because of the mileage and regular services instead of long life they are likely to be ok :) Just need to find a clutch.

It's booked in for this week. £1200 plus the cam adjusters if required. I'm struggling to find a new clutch to put on it. The usual places don't even stock them. Wouldn't trust a lot of ebays offerings due to the amount of fake stuff on there.

How much will turbo only be?

Are you supplying a downpipe as part of the package, or will any 3" aftermarket downpipe be suitable?

Anyone had these replaced? My dads chains have stretched or the tensioner is on its way out so needs doing. Manual gearbox, how much? I know Audi is around £4k

Im in stevenage, fitted loads of cruise kits for various vw/audis, including my s3

My S3 (APY) for as long as i can remember, needs priming twice to start it, otherwise it will crank and crank forever and not start. Replaced fuel pump and filter, no difference. Now, unless i give it some throttle when starting, it dies straight away, and the idle is terrible. No fault codes...

Location? Someone on here will have vag tacho to do it for you.

Yeah i've been looking at the S4 wiki and using nefmoto. I wouldnt ask someone to tell me their secrets as it were, just trying to get a better understanding of wether my tune is actually any good. Will be refering back to the S4 wiki later and having a bit more of a look! By comparison...

When you map an S3 for stage 1, do you alter any of the ignition and injector tables, or leave them stock? After downloading and comparing my 'Stage 1' map to a stock file, all that's been changed is the boost, and lambda tables, which to me doesn't seem enough, and I expect why i've been...