Recent content by Nagasaki

Looking for some feedback on engine condition. Turbo failure on my forged 1.8t due to some foreign body sucked in. Bottom end was rebuilt with forged pistons and ZRP rods 20k ago (head not so and had done 60k) On further turbo inspection there was excessive bearing wear so tearing down and...

Also wondering whether the bores are okay, as previous cross hatching nearly gone and vertical lines appeared in bores. They feel smooth, with no lip at the top, despite there being a dark line from the top of the cylinder wall to where the first ring likely sits. Sent from my SM-G973F using...

Wonder if anyone is able to offer advice on the Mark's, inlet valve side on the pistons in the picture. Forged wossner have done approx 10k on a K04 Hybrid that let go during the week, pushing oil through the engine. Want to be sure this is normal wear before reassembling. Inspection of the...

Looking for some help for an intermittent misfire that seems to have got worse over last few days, post a recent remap. Replaced colipacks which temporarily halted it but has returned again. Just removed plugs and they're a good colour, but looking into cylinders cold, having been stood for a...

Got HKP back on the Dyno post some basic mods over the Winter, including replacing the cheap Chinese High Flow fuel pump with a proper Deatschwerks D65 (Buy cheap, buy twice) and the relocating of the air intake back down to where the Secondary air intake pump used to be. Big thanks to Ben at...

Well, a late night drive led to a complete coil pack failure on Cylinder 1 and error messages for multi misfire and low bank sensor readings. Swapped out an old spare at the side of the road but still playing up, so have ordered a compete set of 2.0TFSI red coil packs and adaptor plates. A bit...

Sent from my SM-G973F using Tapatalk

Been in for first session of the year (3rd since build) and looking for any pointers on a misfire that comes and goes under acceleration, but does not show up on the Dyno. Some good results today with big improvements in the mid range, however and all great on the rollers, but under heavy load...

Just finished ground up rebuild of our forged 1.8t Hong Kong Phooey, moving from original B7 fwd chassis to a B6 Quattro, but kept/transferred the front end as prefer the later lights and grill. Still a work in progress. Sent from my SM-G973F using Tapatalk

Hi Prawn. Just watched your 1st video post of your S3 track car. BAFTAs await a plenty.....Understood that you ran a K-04-64 Hybrid for a while and wondered if you could point me in the direction of some help getting mine to run properly. Thread of the build is on here...

And a few days out of the paint shop........ Front headlights changed to clear indicator versions. The B6 loom is different so be warned. While I was able to rewire the main headlamps courtesy of some help for various Audi sport net forums, I have not been able to get the adjustable motors to...