Hi
Mine is a facelift model, didnt know if there was a differance in the moldings between the two so cheers for that incase I need to go to the scrapy
cheers
Hi
I scraped my rear passenger door in my driveway ( major FAIL) so am now on the hunt for a trim, do these come as a pack? and are the Saloon and Avant trims the same?
also
Wheres the best place to purchase one and expected cost? Or does anyone have one I can buy?
Thanks
Hello all,
Can you advise or point me in the right direction please?
Every/most time I turn left and pull away there is a slight rattle coming from the passenger side? it does not sound mechanical or suspension related, its more of a sound a loose bit trim or something like that would make...
Hey all,
Today the car got a new DMF wheel and clutch kit as the horrid pedel vibration was doing my head in, the car now changes through the gears very well and so much more plesent to drive!!
I have the car booked in for a full service soon, I was wondering is there an Oil service for the...
Hi,
I was thinking of running all the speakers through the 4ch amp and a seperate amp for the sub. I have all the existing amp's etc from my old Corrado so just a matter of pluging it all in. I think the amp I have is a mono if not it can be bridged so no probs. Just hoping the h/u has two...
I'll see how I get on with the pedel, I think the clutch/fly may be something to consider replacing later, I'll check the engine mounts too Cheers.
As for the sub/amp, looks like ill be running some fresh cables from front to rear, the way your describing it I might have to put in a 4ch and a...
Hi aragorn thanks for the reply, I have been ploughing through the forum and noticed your a bit of a guru on the B5, nice motor you got there fella.
Today I checked all the tyre pressures and found the drivers front quite low, after pumping it up, the vibration on the clutch pedel has pretty...
Hi as above just got my hands on a B5 avant.
I have a few questions below
1) The clutch pedel vibrates a bit on idle I suspect from looking through this forum that the dual mass fly wheel needs to be replaced? anyone done this? is the solid conversion really worth it on a Quattro setup? any...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.