Recent content by laurie89

When i first start the S3 it has an ever so slight missfire when underload for a couple of seconds then after that everything is fine, had it scanned with VagCom and confirmed a missfire on cylinder 3 (i think it was that one) so I've been looking into replacing the coils and spark plugs and...

Well to be honest I do need two rear tyres and a new front shock because it's burst, all of which should be here this week, will get this replaced first, alignment done and clear the codes and see if it changes anything from there, if not then the servos getting it

That was lucky that it sorted the other faults, I'm going to have to get this on vag com again, hopefully I'll find a sensor somewhere that needs replacing rather than replacing the servo :/

What fault codes was thrown up when you had yours checked?

was your's showing the same codes?

Is there any way to check it's working? Or do I need a replacement? Thanks

Thanks what is the brake recognition switch? Is that the one at the pedals?

Hi thanks for your reply, what I've posted is what came back after clearing the codes, is it definitely the pump that need replaced or could it be the servo? Anyone had any experience with this type of problem Before?

Bump

VCDS Version: Release 12.12.0 Data version: 20130910 Tuesday,01,October,2013,20:41:17:40973 Chassis Type: 8L (8L - Audi A3/S3 (1997 > 2003)) Scan: 01 02 03 08 15 16 17 22 35 37 45 55 56 57 75 76 VIN: WAUZZZ8L821016053...

Hi, I've recently bought a 2002 Audi S3, and when i bought it the esp light was on. I've had it over to a friends house and he used his VAGCOM on it and came with the following results:- address 03: ABS Brakes 2 faults found: 00814 - Solenoid for Brake Pressure (n247) 35-00 - -...