Recent content by jakobsen

Hi i have some problems whith my 99 8L S3 i did some street race and got the car into 3 instead of 5 gear, i got hold of the clucth before it got to 8500rpm, but after that i now have som small whine in the car, and it's almost only when i coast, ore try to hold an steady speed, i cant realy...

it is easy to change when the rpm it not over 6000rpm.. then there is no problems at all. it's only when i rev it over 6000rpm it gets hard to get in to gear, i did actualy think of changing the bleed block on the bearing, i read there is an restrictor in the plastic stock one, dont know if...

Hi i have a problem shifting gear from 1-2 on higher rpm, 6800rpm and up to 7600rpm limmet. I can easyly shift from 2-3 and 3-4 and so on, no problems at all. it dosent crunch it just dosent goes in gear :S i was told the car has an Sachs clutch kit, but not sure i just know that it's not...

Did you get the car working whithout the hesitation ?? i have the same problem :( but running non OEM Ecu whith Map sensor and no MAF

Found my problem the gearbox suspension was on it's way out there was only one bolt holding the transmission :O

Hi i have som bad problems whith my 99 S3 8L. it started as rumbeling from the front, i knew i had an bad CV boot, so changed my drive shaft to an new, but after the new came in i still has the same problems :( i jacked the car up and disconnected the haldex drive, and put it in gear and then...