Recent content by Goonas

  1. G

    ESP Error after fitting S3 pedals

    Thanks for the information. How do you do this part ?
  2. G

    ESP Error after fitting S3 pedals

    Ok, upon closer inspection one of the wires was loose, and now its not attached at all into the multi-plug. It would seems I've stretched a wire away from the connection, so the big question is how the hell do I get the wire back in, the end of the plug looks like it has ISO clips in it, with...
  3. G

    ESP Error after fitting S3 pedals

    Its odd, the car was working fine before hand - no issues, then I change over pedal and its all gone wrong.. Now I get the following error message: 008487 - Accelerator Position Sensor 2 (G185): Signal too Low I've tried pushing the plug in more, but it still seems to be the same. I put the...
  4. G

    ESP Error after fitting S3 pedals

    Just realised its not an ESP error but an EPC one !! When I try to accelerate, it gets to 3-4k rpm and just struggles then on....
  5. G

    ESP Error after fitting S3 pedals

    Thanks for that. Do you know if the wires can be removed and put into another plug? Tempted to buy a new plug from Audi then I know its 100% seated correctly.
  6. G

    ESP Error after fitting S3 pedals

    After struggling to fit the S3 pedals, and in particular removing the wiring, one part of the plastic clip broke, but it was only the grey bit on the top. So plugged it all back in and now get ESP error message (signal too low). Reset the code using VCDS and it came back straight away, so...
  7. G

    Gave the Engine Bay a quick spruce up...

    Thanks :)
  8. G

    Gave the Engine Bay a quick spruce up...

    Started with this.... Used These... And ended up with this:
  9. G

    Herts Alarm Beeps

    Of Course. :)
  10. G

    Herts Alarm Beeps

    OK Chris, just let me know when is good for you :) It sounds like it will only take a few minutes anyhow. :)
  11. G

    Herts Alarm Beeps

    I am away at the moment but I am in Stevenage. The downside to this is I have only just started to learn how to use VCDS so if you can get some instructions on what to do, then you are more than welcome to use my laptop and cable - Free of charge of course I am back in the UK from Thursday...
  12. G

    A3 8P 3Dr Drivers Door Arm Handle/Rest Help

    From start to finish this job can be done in under 10 minutes without rushing ;)
  13. G

    A3 8P 3Dr Drivers Door Arm Handle/Rest Help

    I just replaced mine because both parts had cracked at the top - the inner and outer part of the handle My part numbers and prices (excl. VAT) are below: A8P3 959 522 A7 PE (Bracket) 12.20 A8P3 867 174 24 A (Armrest) 52.66
  14. G

    Can this be repaired?

    Thank you both for this :)
  15. G

    Can this be repaired?

    It's a phone holder. 1. I didn't realise the hole behind it was that large. 2. An item like this wouldn't put me off buying a car, anyway, with all other things considered.