Recent content by gavbey

Hi there buddy. Yes the bkd engine is In. I had to swap the sump. Modify the oil pickup swap rocker cover and the rest just fitted as per usual. Oh and I also fitted a flywheel spigot needle bearing as the engine I got never came with one I also fitted a timingbelt and waterpunp to the new...

Can't Beat a good old 1.9TDI Ive just bought a 2.0TDi and the balanceshaft, chain etc has went. ill be replacing the engine with a stronger engine without balance shaft and funily enough the oil pump system on it is near enough identicle bar some part Nos to the 1.9TDI :)

Soooooo BKD,AZV and BMN have NO ballancing shaft so i will be going for one of these engines. im just looking for a bit of conformation if they will physicaly fit to the existing longulated transmition? Also Would i need to run the same ecu as the engines? or could my BLB ECU work...

so after a few hours researching am i right in saying the BKD engine comes with gear driven AND no ballance shafts? would it be a case of swapping the block and head for my BLB one? it certanly looks that way? from what i gather the geared version is stronger HOWEVER the geared version...

Perfect thanks for the reply. ill have a look into them. i dont think mine had DPF but ecu and imobilizer wouldnt be a problem as i have VCDS and coding imobs and ecu is a 2 second job. 1.9 oilpump.. hmmm that might be a modification i could do myself.. ill have a look into it. ahh yes i know...

i should also add im handy with VCDS if need be. What codes can be used BKD engine? any 2.0tdi engine? golf? scoda? audi? Thanks Again

Hi guys, After selling my old B5 i missed the Audi A4 so ive bought another... But this one is a B7 I bought this one for cheap because the engine has blown. supposedly balance shaft failure and timingbelt? The car is early 2005 2.0TDI BLB engine code. I will be buying another engine and...

i have enabled it at the can page (gateway) and tried with parking assist bud didnt understand how to do the long coding.?

yes i have the 13 pin one and i have genuine vag-com/vcds im not sure how to work the long coding though thats the problem :)

hi folks, i have a audi a3 (8p) 2.0tdi 07 plate i bought a towbar and genuine audi module for the towing electrics box. i have a full version of vcds (vagcom) but not very good with using it. i cant turn the trailer electrics on. could sombody shed some light on my problem and give me a...

haha cheers mate, yeah the pipes do look a little bit small but they will do for justnow, nope that chip is somthing i made at work, its a 1k potentiometer with a 510 ohm resistor in series, its wired to my fuel pump which tels it to dump more fuel in. makes an unbelivable differance in...

CHEERS GUYS. here is some more pictures including the chip i made. all coments welcome. :)

got a little present through the door. do you guys know what this is? hehe

thanks mate. yes i raised it as the sump and sub frame scraped most of the cats eyes off the road when overtaking ha! its raised up a fair bit now. my plans are chrome headlights ( i know audi owners hate them ). need to find bumper wings and bonet ( in red ) ive bought a3 leather seats (...

well i bought the interior. looks like i will be geting the hammer and welder out haha. pysicaly they fit but the mounts are different, ill get some pictures :)