Recent content by frank s3

hi guys, swaping my engine over as the shells for my crank are in the sump :-|! just wondering what gaskets ill need? inlet,exhaust all turbo gaskets and copper washers ? as im droping the subframe guess ill need steering rack copper washers is their any others ?? thanks frank

Sorry wrong numbers they are- S1J0615423E and S1J0615424E

The part no is 0229

Got a sticky rear caliper and was woundering if lcr pnes will fit??

Is this the kiddy?? 28045462590 (ebay)

Is that the carbon kevlor one dude??

Ok thanks guys i may go for more power in the future and i dont mind it bing non oe just dont want it going wrong again i was going to go with dmf sachs carbon kevlar clutch but think a solid flywould be better as i do give it stick when i can!

alrite guys had issues regarding clutch i fink its the release bearing but im going to change the whole thing as its alot of work plus money if goes wrong again can any one recommend what clutch kit is best??

I think its more terminal like release bearing judging from the noise just cofused of the banging sensation through the pedal

was on my was to purchase some tyres and my clutch started to judder under my foot i turned round and drove home it has seemed to get better on the was but don't seem to be slipping and out of gear a slight werring noise! got a feeling its something expensive :( any help or advice would be...

hiya ive had falken 452s on my s3 for a little while now and cant seem to get them from camskill or any others i was looking at either Yokohama prada spec 2s or the hanook k117 if some one could tell me wot are better would be appreciated i know theres lots of reviews on line but none seem to be...

hi guys bought a new aerial its a shark fin type connections were different so i cut and soldered the earth and reviver works but where i switch my lights on i loose all signal :-/ i moved all the internals from my old Arial base as there was a chip board inside any help would be great and also...

Yes dude they are the xenon i bearly touched it and it came loose do u know if you can get replacement clips??

Hi guys, was changeing my diped headlamp bulbs and was unscrewing the small ring and the hole inner unit came loose i cant see and clips is it ment to be like this?? Its a face lift! If any one could shed some light on this would be a great help thanks frank

hi guys my friend is currently looking to buy the above car and was just wondering if there is anything i should look out for in particular that fails on on this model any help would be appreciated thanks frank.