Hi,
Could someone let me know what the part number for the brake fluid reservoir and the two grommets is? Or alternatively could someone give me the VIN of a 1.8T (mine's a '99 but I don't think it matters). My audi garage say they can't look up to see if the parts are in stock as the car...
I'm not using the eezibleed but thought 20psi should have been ok for the reservoir, as you say maybe it was an existing weakness. I'll stick with 15 next time round though :thumbsup:
Sorry to bump a slightly old thread, could anyone advise what pressure to use with a bleeder kit?
I tried to bleed mine today and the brake reservoir split and sprayed brake fluid all over the car and garage (roof, boot, bonnet :ohmy: ). I'd pumped to 20psi.
Going to give it another go...
Thanks for the offer, I'll hold out for an S4 one I think though. Managed to get it to sit reasonably now and it's just the corner that sticks out a little so in no rush to sort it properly anymore
On the bumper, the carrier below the wings seem fine and it pops onto those but it seems to just come off again. The ones that are broken are the ones that would clip into the elongated holes in the support bar
Great, I'll lookout for one of those then :thumbsup:
A couple of pics showing the damage
It looks a little the same the other side (a bit like the bumper has been "stretched" wider than it should be and it doesn't seem to stay on the side clips properly)
I'm going to have to get...
Hmm, is the wonkiness noticeable (was your car that got me thinking of an supermarket replacement :) )? I want to avoid fibreglass definitely I want a good fit lol! I thought the genuine rs4 bumper doesn't fit properly as it needs the wider wings?
It's silver :( I'll take some pics later after work to show the damage.
Found this
AUDI A4 FRONT BUMPER NEW PAINTED ANY COLOUR 95-99 on eBay (end time 07-Oct-10 10:03:15 BST)
Although I'd be tempted to go with this if the quality was good
Audi A4 (94-01) Genuine Rieger Front Bumper...
:banghead: really pee'd off, managed to catch it whilst reversing out of the garage so all my own fault. The corner has creased and I can't get it to sit right any more (a lot of the plastic catches have broken off).
Is it feasible to repair (recommendations nr bristol if poss!) or is it a...
As per the title really, I bought one of ebay which I fitted this morning but frankly the quality's ***** - the bonnet release lever doesn't fit through the grille and the plastic it's made from is fairly poor (snapped some of the catches when pushing it in to fit!) but then I guess I should...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.