I had to do the xenons on my housings and had to go via the wheel well. Follow this DIY to get much easier access to the back of your headlight housing for replacement. VWVortex.com - DIY: Changing/Conversion HID D3S Bulbs on Audi A3 2010 w/ DRL Bi-Xenon Headlamps This should work for access of...
Ash I've been keeping an eye on this thread. I retrofitted the the Bi-xenons+leds in my 2009 a3 and I want the CH/LH function but I don't have auto wiper light sensor installed. I have been told to get CH/LH function I need to install this headlight switch that you have pictured. Do you know if...
Ash,
Can you do me another really small favor. If you get some time, I'm looking for the location of the pins that control the brake lights on the most inner part of the rear lights. You know the part that is on the hatch of the car?
Okay, I got my VCDS today and I'm going to try and recode these and I'll report back. So frustrating that I lost the rear leds to pick up the headlight leds...I hope this works.
edit: just saw what you wrote two days ago...Maybe I'll sacrifice one of the three rear brake bulbs for a power...
Okay, well I ordered the Ross-tech cable and it won't be here until wednesday so I'll have to wait on the coding end. Originally I went down to my local shop to have the coding done and went back there when I realized my rear LEDs weren't working thinking it was a coding mistake we made. We...
Okay, got a chance to try this stuff out and here is what I run into. I put the front DRL wires into plug A/pin 8 and plug D/pin 9. Reconnected the wires for the rear LEDs into Plug A/pin 7 and plug D/pin 10. This resulted in the rear LEDs working but they also came on as soon as I put the...
Oh, okay. I was wondering if that was something that Audi does. Well I don't have elsawin, so if someone could be kind enough to provide that info I'd really appreciate it.
Yes, I removed the pins for the LED DRLs on the kufa loom and put the original pins back in the same location and the rear LEDs lit up. Currently, cause I don't want to roll around without rear leds, I wired the rear LEDs into the location for one of the three rear brake lights and programmed it...
Okay, I have a 2009 A3 and I did the halogen to Bi-xenon+LED retrofit using the kufatec harness. I needed to wire in the leads from that harness into the CEM at the following locations: Plug A, pin 5 and 7 then Plug D pin 6 and 10. When installing the Kufatec leads I had to remove two factory...
a3rider,
You have to take the bumper off to get those bulbs out, no question about it. You just can't good enough access while they are still in and it only takes about 15 minutes to get it off. I've been following this thread as I have a 2009 "face-lifted" A3 that came with the halogen...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.