Recent content by davsmith64

Well, Before the car went to Audi it had dpf & egr delete done. But I took it back to the tuners to put it back to original. So I know for certain its not remapped. Infact I could send you a copy of my CMD / BDM flash read. I am a mechanic by trade but didnt want to let on that I am to audi. I...

They just didn't seem interested at all, and just wasn't helpful what so ever! I asked what to do, all they said was, we don't know! they said that it was the mapping to why it wont pull, I know 100% its not because its run fine for the last 12mths! they then said that the diesel wasnt...

Ok, Last week my Audi A3 TDI 170 lost lots of power, like there was no turbo pull on it at all!! but not in limp mode!! No EML! Took to a local garage, NO FAULT Codes! But they found my diesel to be black and contaminated with oil and they suspected it was injector fault. So i booked the car...

Sorry but u are 100% wrong.. the car doesn't have a clutch switch.. I gave already checked. Had all the panels off underneith the collumn. All it has is a hall sensor. Not a clutch switch. I'm a mechanic by trade and this is baffling me. Alao if u read further up, ive tried all combinations...

Ok. In group 006 measuring blocks (engine) Stalk pushed back in off position - 00000000 Stalk pulled one notch to on - 10000001 Stalk pulled to resume - 10100001 Stalk pushed up - 10001001 Stalk pushed down - 10000101 Stalk to cancel position - 10000011 This is how the stalks registering. Now...

I answered the question in my first post.. everything registers apart from the SET button. I will try recode the engine again. Yes all faults are cleared and the control unit accepted the coding. I just dont understand why its not working. EDIT.. Recoded again as u said to try. Still not...

Ive tried pulling the stalk towards me and up. Tried it every way possible but still its not working. Dont get the cruise light on cluster either. But the stalk is from a earlier a3 8p (2003) my car is a 2007.

Ok, Ive fitted a stalk & recoded the ecu & steering wheel., however the cruise control is still not working.. part numbers are, Stalk - 8PO 963 613 Steering ECU - 1K0 953 549 AH When i do tests in VAGCOM its showing all the functions are working on the stalk apart from the set button. Anyone...

Hello All, My a3 Tdi doesnt seem right to me, Between my gear changes the revs seem to raise when the clutch is pressed! say if im at 2000rpm and change gear the RPMS raise between gear changes! surely this cant help the clutch. At the minute im having to change gear by releasing the...

i will try this tomorrow. Will let you know how it goes.

Still have this issue? Does anyone know exactly where the clutch switch is? regards dave

Ive looked above the pedal and cant see it at all. had all the under cover off to look for it.

Nobody any ideas? Thanks Dave

Hello All, Ive just fitted Retrofitted Cruise Control Stalk & ECU to my A3. Coded it all in correctly, In Engine & Steering However it dont work :/ In VCDS i go to Measuring Block 006 in engine. It shows my brake switch is working, however doesnt register anything on the clutch pedal. I cant...

anyone?