Recent content by Dan5115

Hi all, bought a 2008 A5 3.0tdi quattro a few months back and have a intermittent dtc in vcds relating to egr insufficent flow. No dash lights however and dont believe carbon build up to be an issue as i have checked this and is fairly clean for 88,000 miles on the clock. Also believe a...

Ok, cheers

Hi all, bought a 2008 A5 3.0tdi quattro a few months back and have a intermittent dtc in vcds relating to egr insufficent flow. No dash lights however and dont believe carbon build up to be an issue as i have checked this and is fairly clean for 88,000 miles on the clock. Also believe a...

Thanks for your reply, kinda makes sense that they may be running in some kind of “fail safe mode” just weird how it’s intermittent and they operate fine sometimes then others they don’t. I do recall a fault code stating “30amp open circuit” or something a while back when I did a vcds scan...

2004 Audi A3 3.2 fans occasionally run constantly till battery dead or f8 fuse pulled. I’ve had an auto electrician, and an Audi mechanic look at it and both told me it was fan module so I replaced with new unit and it was fine for first week then it was doing exactly the same as before. My...

No wire but now fitted and new module and slip ring installed just need to code it all, decided to swap for AH module as heard all other early mid/high line modules besides the AH module cruise control works but not fully as intended. Thanks

Thanks for your reply, I currently have module 1K0 953 549 A and I’m replacing it with 1ko 953 549 AH along with type2 slip ring 1K0 959 653 D as I’m lead to believe it’s the only early module where cruise control works as intended. Yes I’m aware I will most likely need the wire however I’m not...

Hi all, Im looking at fitting cruise control and got all the parts including new steering module as my current module won’t support it. How do I code it to my car? I can only find a guide on the A4 but I assume the codes will be different? Thanks for any help

Hi all, Im looking at fitting cruise control and got all the parts including new steering module as my current module won’t support it. How do I code it to my car? I can only find a guide on the A4 but I assume the codes will be different? Thanks for any help

Thanks for the cowling tip, got the rest of parts ordered however does anyone know the difference between 8P0 953 513B and 8P0 953 513?? I assume the “B” is a later variant but will the 8P0 953 513 do the job as I can get it for 1/3 of the price of the other.

I think I need the following to get CC working spot on, if anyone could check and confirm these are the right parts as the info I find online seems to contradict each other source. Only need module support for full functioning CC as MFSW isnt necessary. Stalks - 8P0 953 513B or 8P0 953 513 ...

Hi all, Can anyone help me with the correct stalks and lower cowling to fit a 2004 3 door 3.2 a3, 8p0 054 690 and 8p0 953 512a? I read that I'll need the extra cable from ecu to blue thing but will I also need a new steering module for cruise control to work perfectly? If so which module and...

Hi all, Can anyone help me with the correct stalks and lower cowling to fit a 2004 3 door 3.2 a3, 8p0 054 690 and 8p0 953 512a? I read that I'll need the extra cable from ecu to blue thing but will I also need a new steering module for cruise control to work perfectly? If so which module and...

Sorry to bother you again but when you say caliper to brake carrier, do you mean the 4x T55 bolts or the 2x 7mm guide pins? It's the 4x T55 bolts that I'm struggling on torque settings on as it seems like they don't exist, don't suppose you know or have the rear brake caliper torque settings at...

Thanks a lot, they'll come in handy tomorrow :yes: