Recent content by Cookie013

It's a shame to sell them really but I can't run this daily where I live.

Well I have to use 25/30mm spacers to clear the brakes haha. Which leads to this:

I've got 10mm up front but I don't think they will cut the mustard haha. But I can't really stick bigger ones on:

I haven't got the discs so that's ok :) haha. Thanks for the link, I'm not sure my fifteen52 snow flakes will clear the brakes now :( haha.

So just to make its clear you can't use the rs3 discs?

A bit to small :( thanks for the link though dude.

Thanks for the info dude it's just trying to find some now haha.

I though that I just wanted to know if any one could tell by the codes haha. I've read that to I just can't seem to find any TTRS discs at the minute :( thanks for the help dude. I know it's a good deal what i got, but im just clueless to what they came off of a rs3 or a tt? And to what I...

Hello, I'm managed to some how get my self a good deal on a ret of RS3 or TTRS brakes I was just wanting to ask a few questions if someone shouldn't mind helping me by answering them. What brakes are they? I got these codes off of the back of them: I think they are the TTRS ones because...

You can either get it on a ramp (much easier) or jack it up both sides take the plastic tray off the bottom or skid plate depending on what you have and it's the mount from the gear box to the sub fame. Just check all three bolts to make sure there tight.

It's all fixed now thanks for the help lads! It ended up being the dog bone mount had broken yet again, but this time it was kept tight up with my slam panel on the bottom of the car so i couldn't feel the movement but It could move enough to hit the drive shaft! It's just the low life I guess.

From that To that I may have taken more off and I took some plastic off of the bumper above the fog light as well. If you can see that.

No I haven't had it fitted. That's because it's jacked up in the picture. It's under slight acceleration and when I turn the steering wheel.

That is true dude thanks for the info I will keep this updated with what the problem is.

I will post done on here when I get in from work later and I need to get a new one because mine is missing the chrome bit. I just got the grinder out and just took a little bit at a time off until it fitted correct.