Recent content by CagaA4

I've now also installed as a punt the H revision master cylinder and pressure bled the clutch. I still can't start the car as it thinks the clutch is up... If I undo the bleed valve on the slave and press the lifeless clutch to the floor, it allows the pedal to travel further to the floor and...

Yeah there's three position sensors actually, hall sensors. I've read that it's a crap design and made worse when using aftermarket clutches. The question is, how do I fix it if the clutch is new, master cylinder is new sensor works and clutch bled. I've read people sleave and extend but...

Ps, the old master cylinder after inspection has disintegrated, loads of plastic bits fell out into the return line, which I've cleared. The fluid is super clean and clear as it bleeds from the slave.

Hi All, I had an issue with my clutch master cylinder that meant it needed replacing as it wouldn't start. The workaround was to grab another one and connect it to the harness and push the rod down to test, which worked fine as expected. I went ahead and replaced it and without bleeding...

I have a 2010 2.0 CAGA engine A4 which has heavy black smoke on acceleration and a rough idle on cold start and down on power in 2nd / 3rd while it's piling smoke out the back. It's recently had a new cambelt, fuel injectors, fuel filter, MAF and air filter. The car has zero DTC codes in VCDS...