Recent content by jim potter

  1. J

    Audi A5 module fault after rear brake change

    hi, so i have a module fault after a rear break change on A5 2.0 D witin the parking brake module vcds reports 61568, U1113 00 (137) my current genuine cable wont report in full as its not new enough. im aware there is a specific way to change the rear pads. the garage did wind them off...
  2. J

    removal of c pillar trims

    HI there, just retro fitting DAB to my 2.7tdi. looking at how the rear trim pieces come out ? specifically the passger side c pillar and seatbelt plastics. any links or guides.
  3. J

    DAB Retro fit with BOSE amplifier.

    parts used are https://www.ebay.co.uk/itm/264994704479 https://www.ebay.co.uk/itm/153719262638 AUDI DAB Radio Tuner Control Module 4E0035563 its all in and working, but need to remove the c pillar trims. Any tips ?
  4. J

    1.8T M3.8.3 tuning

    do you have any Tunerpro definitons for this ECU ? Old hat for most but of interest to me.
  5. J

    DAB Retro fit with BOSE amplifier.

    Unit fitted and working, stuck it behind the cd player and looped it in with the cable. swapped out the FM aerial and suprisingly it does pick up quite a few stations on DAB. What aerials are being used by most. will the standard Audi unit work if i swap over the amp for it.
  6. J

    DAB Retro fit with BOSE amplifier.

    For those with the same setup , it appears my FM Radio is intergrated with the Cd Player in the glove box (not multi changer). has anyone retro fitted DAB with this setup?
  7. J

    DAB Retro fit with BOSE amplifier.

    HI ALL, i have a MMI 2g high system, with the Boe amplifer and stock FM radio. i want to retro fit the DAB. i have purchased the parts,inc power and optic leads, but am sturggling to find the am/fm unit. i had initally though it was in the passenger side boot well, but that only appears to...
  8. J

    DAB What are my options?

    Where is the standard FM/AM module located ? back of glovebox ? ive sourced a DAB unit and power adpator and MOST splitter.. so just antenna to sort.
  9. J

    No Heater blower

    yeah its very odd, motor is cheap enough if it does go. While it works i will leave it alone.
  10. J

    No Heater blower

    hi, yes using vcds all flap related items work. oddly i went over a bump and its started working and is still. will be checking wiring and dirty connections. thx for the reply.
  11. J

    No Heater blower

    HI, So currently i have no heater blower. Controls all work fine, vcds reports 00256 Lower limit exceeded, but i guess this just means its out of air con gas. Before i Strip out glove box and front tray, Will/should the resistor or motor throw a code ? any way to check with VCDS ? i've...
  12. J

    A6 2.7tdi Remap

    Hi, so i am after some people from people whom have had this done, on what is the cvt / multiitronic box, on the A6 2.7 tdi. i have seen lots saying dont do it, but some must have had it done. would like some real word feedback. thx Jim.