Recent content by xxbluedragonxx

Hi all The interior pillar trim (passenger side where the airbag sits behind) is not as tight/flush against the roof section compared to the drivers side pillar. Is there anything I can do to fix this? I’ve tried pressing it quite hard but it makes no difference. It’s a small thing but kinda...

Ok thanks that did the trick! Rear wiper fuse in the piggyback socket nearest the prongs. Camera fuse furthest from the piggyback prongs. Plugged it in with the camera wire other side this time (rotated 180 degrees as I originally plugged it in “upside down”) Camera now works with ignition...

photo would be helpful i put the 3a camera fuse in the piggyback where the camera power wire comes out. Wiper fuse in the other hole. does it matter if the piggyback is upside down?

Hi I earthed the camera to one of the two torx nuts to the side of the glove box and used a piggy back fuse spur on the rear windscreen wiper slot (the blue 15 in the bottom right corner) Camera starts and stops with the ignition as I wanted, however, the rear wiper doesn’t work ☹️ I took out...

That seems to be the blue 15 one near bottom right corner?

Pretty sure it’s an 8P hatchback now; it has smaller spoiler compared to the pics I’ve seen of 8V models The fusebox is in the glove compartment.

Switched live. I think it’s 8v actually. the rear window spoiler? retracting screen? My first Audi so not 100% sure

Hi I have an A3 late 2013 and am trying to hardwire a dashcam but not sure which fuse to spur off. attached is photo of my glovebox fuse box. I just need it going on and off with the ignition. Can I use any of the empty slots? Or does it need to be spur off existing fuse? Which one? thanks!