Recent content by ming6068

Can you let me know the exact pin for the installation? Does your car comes with HID headlight or just halogen?

The wire runs along on top of the door frame; does it affect the operation of curtain airbag?

Great! After all the research, I just find out my rear door has no module inside! Only can use the door latch 'switched ground methods'...

For 5F For 09 Thanks for all the input. I am so busy on work until now. I probably will install those on Wed, and specially thanks for the instruction on the pinout. In order to control via MMI you need to code the 09 and 5F module with adaptation. Here are those 'channel' that need to be...

Yes. you are actually Damaging the tab by cutting it, and glue it back together

I believe we can find 'switched ground' instead of 'switched +12V' ??

Stupid question... I did try to find my module beside steering column but found nothing Or is that on the LEFT HAND SIDE same as LHD model? or Audi did mirror it to the 'DRIVER' side (RHD for us as well?)

I just find a soldering iron to melt the tab back together. For the wiring the ideal is to connect to its delicated pin so it can be controlled by mmi Second choice will be parallel to foot light so it can also controlled by mmi Last choice is to the cigarette lighter ring. I will do the...

Everyone is referring to this diagram (Sorry it's not in English for my version) The problem on my version is super 'blur' on the wording. Left 3 wires are the +12 for the cup holder light. (for different car config) There are three different pins for 1. Xenon equipped cars 2. Halogen equipped...

SPENT 45 minutes to remove 10 of those fused tab and replace the cup holder led ring. Only takes 5 minutes to fuse them back together though... Will do the wiring this weekend, and hope everything alright. (Need to find out the correct wiring first)

I have a chance to read through a A3 8V SSP and find out they actually listed IF the car has no light package or 'Remote Child Safety Lock' (it's a translation as the manual I read is not in English) or Rear door has not equiped with the central lock switch; the J388 and J389 module will not be...

It's better to have Elsawin to check the wiring diagram to confirm But according to my source it should be J519 T73C plug, pin 3 (if you have Halogen headlamp) or pin63 or 53 (for Xenon, and that's the worst part as my copy of wiring diagram can't read clearly)

The J519 on MQB A3 (our A3) should be same as the Golf mk7 one, which has a 73 pin , 39pin and another 'many pins' connector. You sure there is a T10a there? I read the instruction from my local supplier, it is pin 3 on the 73 pin connector... footwell light is pin 72

Page 2 from my previous reply, the light should wire to the door module 16 pin plug (if you have the module) pin 12 will supply the +12 power if the door is opened (and if enabled by coding)

You DIY with the coding or find shop to do the coding? I believe we have a very clear direction on the wiring now; all the matter is about coding.