Bluetak, lol
Nah drill the sensors holes which are 21mm iirc, then I got some A6 brackets which can be bought by themselves, as they arent available for the 8P without buying bumper, then fix the sensors on these, then use minimal superglue to fix the sensors in the holes drilled with the brackets attached, note the brackets dont even fit the bumper & 1 or 2 legs actually have a gap between these & bumper, but as we're packing the gaps out with epoxy or sikaflex this doesnt matter, as when these things set, those brackets dont budge a mm, so effectively the brackets wont ever move & the sensors are removable if they go faulty given superglue is just a placement holder, whilst brackets get fixed to the bumper, make sure you scratch the bumper surface when fixing brackets to it, as it holds much better than smooth surface.
I wanna electronic brake in my A3, but I am not gonna get it, lol.
Nige,
I've been looking on ebay.de at the control units for the parking sensors. Now according to ETKA I need part number: 8P0 919 283 D, but will 8P0 919 283 work ok? Is the D just an updated version?
Quite possibly cause unless they run looms into the front & also you can adjust the sounds in the DIS then its the cheapo kit which are a total ripoff, they're same as the ones on ebay for what now £9.99, I know whats involved with the oem fitment & trust me its not a 5 minute job.
Put into etka the part number without the D on end & it should show if it supersede's to the D or not, it may go A, B, C & then D or even newer, but if it goes to D along the way then you know its compatible, but need to get the correct sensors for that module aswell as they have changed a little over the years in size & technicalities as in some are now park steering assist aswell which you dont want as relies on other expensive parts aswell, the version that steers for you.
care to share why? LOLIf its been superseded then you can use any one of those 5 units mate as even old cars use the newer D modules & they're originals were the non letter version & the bracket should already be in your car hidden behind the drivers rear quarter boot cover thats sprung clipped in place, funnily enough I have to go into there tomorrow to fit an updated cnvenience module, so might grab some pics.
You can easily goto audi mate & ask them to list them for you, 4 sensors, control module, 2 looms, now you cant buy the main controllerto car loom, but sensor to controller loom you can, repair wires yes but cant get loom from audi on its own without the rest of that area wiring, question is now mate do you want the proper system that integrates with the cars CAN system & possibly shows in your DIS to change sound settings or do you just want the cheapest going that works of reverse wire?
Be warned either way you'd need to drill the bumper out as you cant buy brackets for the bumper sensors, its new bumper totally that comes with the brackets (stuck on with double sided tape, yes double sided tape, wtf) so I got some A6 brackets & superglued/epoxied them in place with sensors, I preferred oem style & love it, now gonna look at fitting the fronts aswell.
Kinda guessed as much LOL. I think your up to something....A control module K.
the bracket should already be in your car hidden behind the drivers rear quarter boot cover thats sprung clipped in place, funnily enough I have to go into there tomorrow to fit an updated cnvenience module, so might grab some pics.