it's just 4 screws for the install, isn't it?
Looking good James!
You cant complain for a price of a Takeaway eh!!!
You must eat more than me
have you bonded it as well or just screw,d it on ?
so are you going to tell us how to do the perfect job or is that the secret of 2010 lol
It's not quite that simple in fairness. In addition there are two legs in the centre, these either need trimming to fit, or ideally you would need to cut two square holes in the underneath of the bumper. These legs are designed to push through the hole and then the springs in them will 'clip' into place and hold it firm.
The splitter also needs both ends cutting back as it is too long for the A4. You can either just cut it off square, or taper it back so it has the 'factory' effect of fading in to the wheelarch.
Would the Cupra R splitter work OK with the Votex lower front bumper?
****** that was short lived , More bonding needed next time .whoops!!!!
mine is off.... doesn't work so well as a snow plough... I'm keeping it off until the snow is less that about 6" deep on my nan's road (currently over a foot deep)....
whoops!!!!
mine is off.... doesn't work so well as a snow plough... I'm keeping it off until the snow is less that about 6" deep on my nan's road (currently over a foot deep)....
Did you take it off? I can't believe it ripped off
Mine was ok
And lostbok, your wheels look stunning! (the car looks good too, but I am in love with the wheels) Infact, are they darker than standard or just dirty? ha. I did that on my old 306 a few years ago. I wanted darker wheels so I refused to wash them for months. It gave me the nice grey/ anthracite look i wanted until my father in law rubbed his shoe down it pointing out how dirty they were!