All done, cheers for your help.
Didn't need to move the pin, as there is already one there on mine (08) model.
Hi guys,
I'm expecting my RNS-e to arrive at some point this week, would 0205715 be the correct coding for my options below:
Standard sound system
Bluetooth
MFSW
Cheers for your help.
There is a wire present, but it's now not connected properly. The concert/symphony ii+ units (the one you took out) has the BOSE pin on B-5 and the RNSe requires this on pin B-7.
You've now got your bose wire connected to the RNSe k-line diagnostic pin, (which is used if the RNSe is fitted to an A4) It needs to be connected properly so the correct Bose EQ pattern is used.
So what do I do with the wire in B7?
Nice one
Where does everyone mount their GPS receiver??
On top of the glovebox or above the RNSe between the airvents. I know it sounds daft, but you can still pick up up to 7 satellites from under the dash!
Pin D13 is the remote on wire for the rear amplifier....
You need to code the car and the RNSe first with vagcom, that way you can be sure the car is sending the on/off signals over the CAN bus. This alone may fix your issue, if not, then look at the wiring in the adaptor harness.
sorry to hijack, but just fitted RNS E tonight, placed GPS Antenna on top of the glovebox itself, using sticky backed tape, after dropping glovebox out, the gps is showing direction on DIS but wont pick any satellites up, best ive had is two when parked up. I understand i will have to code but will this make a difference to this? can anyone tell me what coding i need? my spec follows
basically poverty spec!!
- S3 standard wheels
- No MFSW
- No Bluetooth
- No cruise
i done mine few months back but never coded it and it worked good, i first had the gps like how you did but only used to get 2-3 sats max, than move the gps behind where the twitter is (behind a piller) and now getting 6-7 sats
does anone no what lead i need for a 2001 audi a3 1.8t
does anyone no what lead i need for a 2001 audi a3 1.8t
Hi sorry for jumping in guys I'm going to try and code mine soon. It's an s3 8p. But with no mfsw. Had got bose. Bluetooth. And cruise control. I'm guessing mine won't be the same as this code will it. ThanksCoding is the same as mine then 0209717.
You can code the tyre size (although it does self calibrate) and startup screen options if it's still the S3. You'll need to code the CAN gateway too to tell the car it now has navigation.
Here is the RNSe bible from Navplus/Audiforums.us
Is it safe to assume it's still an A3/S3? You did have the car up for sale?