- Joined
- Jan 10, 2003
- Messages
- 402
- Reaction score
- 0
- Points
- 16
I've just installed a B&M short shifter. Putting everything back together was most time consuming part because of the limited workspace in the drive shaft/housing. But it's brilliant kit, I'd definitely recommended to anyone.
Just one problem though, the stick keeps falling downwards through the pivot (see pic below). I realise there's a retaining ring missing when I assembled the shifter as per the instructions. So far I have to lift up the stick everytime I select a gear.
I might have to find something that sits above the pivot to stop the stick falling or find something and wrap round it. Or use jubliee clips.
Any other suggestions?
Just one problem though, the stick keeps falling downwards through the pivot (see pic below). I realise there's a retaining ring missing when I assembled the shifter as per the instructions. So far I have to lift up the stick everytime I select a gear.
I might have to find something that sits above the pivot to stop the stick falling or find something and wrap round it. Or use jubliee clips.
Any other suggestions?