I think I contorted my hand so it no longer resembled a hand, then used my index and middle fingers either side of it as a lever to pry it out. Took a good half hour I think.
I may have also removed something from one side as I remember one being harder than the other.
on the 8p1 and 2 it makes life easier if u pop the main (full) beam out aswell. gives u a bit more space to work with. I didn't find it too difficult to do. I don't advise it but sometimes u can tug the wires to help pull it out
on the 8p1 and 2 it makes life easier if u pop the main (full) beam out aswell. gives u a bit more space to work with. I didn't find it too difficult to do. I don't advise it but sometimes u can tug the wires to help pull it out
1 went in fine and working (passenger side) but ive replaced the drivers side and its not working
even after putting the original bulb in its not working
i was very careful with it and used long nose pliers.
Any reason why it wouldnt work? i have tried it both ways
fuse blown maybe
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.