Thanks Karl :thumbsup:
Here is a time lapse of seating the inlet valves - I only used the fine grit paste as the valves were seated properly on the first build.
Once I have finished the exhaust valves, the head with get a good clean an all the supertech valves, valve springs and titanium retainers will get fitted back into the head.
Here is a time lapse of seating the inlet valves - I only used the fine grit paste as the valves were seated properly on the first build.
Once I have finished the exhaust valves, the head with get a good clean an all the supertech valves, valve springs and titanium retainers will get fitted back into the head.
Last edited by a moderator: