Changed injectors 2.0 tdi ,but still not running right

james1985

Registered User
Joined
Nov 17, 2012
Messages
10
Reaction score
0
Points
1
Location
NULL
Hi i have a 2007 a3 2.0tdi engine code BMN has done 80,000, it had injector failure on injector 1,3 &4, i changed all four injectors for new ones and a new injector wire loom all from tps.

the car now starts and drives, but goes into limp mode, with the coil light flashing, code shown is 000665 boost presure regulation p0299 -006 control range not reached.

once the coil light comes on it runs very rough and usually cuts out and doesn't restart with out the code being cleared, and then some times it takes a while.

This is the only fault code,
does anyone have any ideas please?

thanks james
 
very odd to have 3 injectors fail i would say

shouldnt matter if cat d i would go some else
 
Audi dont need to know its cat d all they need to know is that if they dont book it in your going to phone vosa and report the garage then they will fear you and book your car in and give you courtesy car i had a a1 1.4tsi loved it lol ring then up tuesday and say vosa said cat d or not the car can be booked in
 
Audi dont need to know its cat d all they need to know is that if they dont book it in your going to phone vosa and report the garage then they will fear you and book your car in and give you courtesy car i had a a1 1.4tsi loved it lol ring then up tuesday and say vosa said cat d or not the car can be booked in
thats great, i will give them a call and try that, thanks for your advice
 
very odd to have 3 injectors fail i would say

shouldnt matter if cat d i would go some else
I had it scanned on vag com and it said three but some one told me it could have just been a faulty wire loom,but i thought i would just change them all to get the problem solved! But no its not much better.