Hi all,
Thought I'd post a small write up on the correction detail I've just done on my A3. Unfortunately I couldn't get any 50/50 shots due the colour/lighting but here goes....
Tools used
Kestrel DAS-6 and hex logic pads
Brinkmann dual xenon torch
Products used
Autosmart G101
Valet pro snow foam
Valet pro carnauba wash
Bilt hammer soft clay
IronX
Megs 105/205 compound
CG blacklight
CG hybrid V7 sealant
Megs quik interior detailer
Mega endurance gel
It started off with a Juicy package.....
then I cleaned up the arches with G101, I'd already sorted out the rusty hubs with hammerite smooth silver paint and the calipers with black caliper paint
Next up was ironX and clay bar, was really surprised how much crud the ironX removed!
next day I got the car masked up ready for the megs compound. I'd done a test section and experimented with a few pad combinations but in the end the only combo that would shift the swirls was 105/orange hex logic
I then went round the car with 205/white hex logic. After which it was 2 coats of blacklight using blue hex pad and then the CG hybrid. Results are as follows, really impressed with the blacklight/v7 combo
finally did the interior with megs QID
Next up is my girlfriends dolphin grey A3 where i should be able get some good 50/50 shots...
Thanks for looking!
Thought I'd post a small write up on the correction detail I've just done on my A3. Unfortunately I couldn't get any 50/50 shots due the colour/lighting but here goes....
Tools used
Kestrel DAS-6 and hex logic pads
Brinkmann dual xenon torch
Products used
Autosmart G101
Valet pro snow foam
Valet pro carnauba wash
Bilt hammer soft clay
IronX
Megs 105/205 compound
CG blacklight
CG hybrid V7 sealant
Megs quik interior detailer
Mega endurance gel
It started off with a Juicy package.....
then I cleaned up the arches with G101, I'd already sorted out the rusty hubs with hammerite smooth silver paint and the calipers with black caliper paint
Next up was ironX and clay bar, was really surprised how much crud the ironX removed!
next day I got the car masked up ready for the megs compound. I'd done a test section and experimented with a few pad combinations but in the end the only combo that would shift the swirls was 105/orange hex logic
I then went round the car with 205/white hex logic. After which it was 2 coats of blacklight using blue hex pad and then the CG hybrid. Results are as follows, really impressed with the blacklight/v7 combo
finally did the interior with megs QID
Next up is my girlfriends dolphin grey A3 where i should be able get some good 50/50 shots...
Thanks for looking!
Last edited by a moderator: